Completely Waterproof IPX7
Two way waterproof communication package for your helmets with our Bb 3.0 Standard Units.
This package comes with two helmet headsets to install on your own helmet. This package does not include helmets.
These helmet headsets provide complete ear protection. They fasten to your own helmet by a marine grade Velcro. These are compatible with almost every helmet, except those that are rubber painted. We recommend installing onto a flat surface.
The design of the helmet headset allows the flexibility to change out either the microphone piece or speaker piece if it becomes damaged over time.
PACKAGE INCLUDES:
x1: A02SD – Standard 3.0 – 2 Piece Set
x2: B03R – Double Sided Helmet Speaker Pad
** Package does not include helmet. Our helmet speaker pads are universal and will work on most any water helmet. Only restriction is your helmet cannot be rubber painted. If you wish to add a helmet to your order, you can do so separately. Click here to see the universal helmet we offer.
INSTRUCTIONS:
- Link to printable instructions on how to install onto your helmet
- Online Instruction:
- Use fresh water to wash all of the headset.
- Make sure to rinse the microphone and speaker piece.
- DO NOT use high pressure spray.
- It is best to submerge in a bucket of fresh water for a thorough wash.
- Hang to dry in a well ventilated climate controlled (a/c) environment.
- Over time, the male 3.5 jack on the headset may become corroded. (dull in color) Make sure to keep this clean by a cloth or scotch bright. Do not use any cleaning solution.
If using in salt water, you must fresh water rinse. Failure to do so can cause corrosion and product failure.
1. Use the alcohol prep to clean up the helmet surface. You must clean the surface of your helmet to insure the 3m tape will adhere to the surface. The 3m tape will not adhere to rubber surfaces. 
2. Attach the helmet speaker pad Velcro tape onto the helmet, left and right side just above the helmet ear opening.
3. Run your helmet strap through the elastic band on the helmet speaker pad. This is important! Failure to do this step can cause the rubber to rip on your helmet speaker pad.
4. Install the plastic mount onto the left side of your helmet, just above the headset. (The rubberband helmet mount comes with your Advance Unit set)
5. Stretch each rubberband around the waterproof case and secure the band to the bottom of the mount.
6. Plug in the 3.5mm audio cable. Make sure the cable is tight and secure. Failure to do so will cause water intrusion into the casing. Any water damage to the unit within the casing is not covered under warranty.
7. Make sure after each use that your case is secure and sealed.
From the date of purchase, the helmet speaker pads and all it’s components are covered for 6 months. The Bb 3.0 Units are covered for 1 year from the date of purchase. Please see our warranty section for complete warranty details.
