Waterproof IPX7
Waterproof helmet speaker pad designed for certain GATH helmets with single speaker over left ear by BbTALKIN USA.
This pad fasten to the left side of your helmet by a marine grade Velcro. Please refer to the chart above to make sure this headset is compatible with your style GATH helmet.
This headset is not compatible with all GATH helmets. If you own a GATH helmet that does not work with this headset, please use our standard single sided headset.
To be used with our BbTALKIN units.Ā You plug the headsetās 3.5mm audio jack directly into your unit for communication.
Boom microphone has replaceableĀ microphoneĀ andĀ speakerĀ if corrosion starts to build over time when used in salt water.
Here is a helpful video on how this headset is installed on a GATH helmet.Ā This headset can work on other helmets that have solid plastic covering the ear with open vents.Ā You have to make sure there is enough surface for the headset to adhere to.
SKU: B02G
EAN:Ā 4713309040252
Rubber helmet speaker pad, left side with Velcro tape
- Use fresh water to wash all of the headset.
- Make sure to rinse the microphone and speaker piece.
- DO NOT use high pressure spray.
- It is best to submerge in a bucket of fresh water for a through wash.
- Hang to dry in a well ventilated climate controlled (a/c) environment.
- Over time, the male 3.5 jack on the headset may become corroded.Ā (dull in color)Ā Make sure to keep this clean by a cloth or scotch bright.Ā Do not use any cleaning solution. It is best to keep the headset plugged into your unit if possible to help avoid corrosion build up.
If using in salt water, you must fresh water rinse. Failure to do so can cause corrosion and product failure.
1. Use the alcohol prep to clean up the helmet surface. You must clean the surface of your helmet to insure the 3m tape will adhere to the surface. The 3m tape will not adhere to rubber surfaces.
2. Remove the audio vents from your GATH helmet.
3. Attach the helmet speaker pad Velcro tape onto the left side of the helmet over the area where the audio vent use to be.
4. Install the plastic mount onto the left side of your helmet, just above the helmet speaker pad. (TheĀ rubberband helmet mountĀ comes with your Advance Unit set)
5. Stretch each rubberband around the waterproof case and secure the band to the bottom of the mount.
6. Plug in the 3.5mm audio cable. Make sure the cable is tight and secure. Failure to do so will cause water intrusion into the casing. Any water damage to the unit within the casing is not covered under warranty.
7. Make sure after each use that your case is secure and sealed.
x1: Single sided helmet speaker pad with microphone and Velcro
From the date of purchase, the helmet speaker pad and all it’s components are covered for 6 months. Please see our warranty section for complete warranty details.
